EZ Stack Quote Request Form

Submit An EZ Stack Quote.

Internet Explorer Isn't Supported By This Tool

Step 1: Fill Out The Table Below

Overall MoldSize
Imperial (in)
Enter H (Height):	Enter W (Width):	Enter L (Length):
Center Section Of Mold
Enter H2 (Height):	Enter W2 (Width):	Enter L2 (Length):

Overall MoldSize
Metric (mm)
Enter H (Height):	Enter W (Width):	Enter L (Length):
Center Section Of Mold
Enter H2 (Height):	Enter W2 (Width):	Enter L2 (Length):

Step 2: Use The Following Mold Sizes To Pick From The Table Below

Weight:

Overall Mold Size

Center Section Of Mold

Reference Selection Guide:

The balance is more important than the force. Selecting 2 or 4 sets of the EZ Stack mainly depends on the size the of mold. The press opening and closing acceleration is related to the whole moving mass and force, we recommend not more than 2M/S². The center portion acceleration is half of that (1M/S²). For ease of selection, we are using the WEIGHT in the chart instead of the MASS. The recommended EZ Stack in the chart below is for reference only, use the Center Portion Max Weight and the Center Portion Max Sizes to choose the quantity of the EZ Stack Centering Devices to mount on your mold. For Safety, set the max load at 10% of the dynamic load as shown below.

Step 3: Using The Image Below Pick A Size From The Chart Below & Enter D & BL Values

Set D

	Input				Output
	H1	H2	D	BL	Max Open Per Side	PIPE LENGTH	ROD LENGTH
EZS32-1000	650	200		615
EZS32-1500	900	220		850
EZS40-1000	1200	250		1160
EZS40-1500	1500	250		1200
EZS40-2000	1800	300		1600

Your Contact Info

First Name

Last Name

Company

Phone Number

Street Address

City

State / Province

Zip Code

Country