HomeHomeWhat is SelectBase?SelectBase Home

43 Nominal Sizes
9 Plate Thicknesses
4 Steel Types
Guided Ejection
Pry Slots
Lifting Holes
Ejector Housing Cover
Pins, Bushings & Vents
Feature Positions
Feature Mossions
3 Piece/ Welded Housing
Clamp Slot Types
MIxed Steel
Sprue Bushings
Puller Pins
Literature/ Order Info
75 Trillion Combinations

Sprue Puller Pin
The Sprue Puller Pin removes material from the Sprue Bushing at the end of the molding cycle. It’s positioned directly below the Sprue Bushing and is retained between the ejector bar and ejector retainer.

If desired, the Sprue Puller Pin and/or machining for the pin may be omitted.

Sprue Puller Pin Diameter
Sprue Puller Pins are available in three diameters on any SelectBase

• 0.250"
• 0.3125"
• 0.375"

Sprue Puller Pin Length
Sprue puller pins are provided at the recommended length of the stack up of plates in the "B" half of the mold base less 3/16" (1/8" in the case of 88 and 812 mold bases).

You may also order the Sprue Puller Pin cut to length per your specification.