|
|
|
|
||
|
||
|
   
For additional operator safety, SelectBase mold bases include an ejector housing cover, except when a longer length ejector bar is selected. The perforated D-M-E logo helps the operator to visually determine if the ejector assembly is in the forward or returned position. The cover is fastened on both sides with 5/16-18 button-head cap screws.
The ejector housing cover is installed on both ends of the ejector housing to cover possible pinch point areas to protect the operator.  To permit installation of the ejector housing cover, the ejector assembly and housing are modified from the illustrations in the D-M-E North American catalog as follows: The length of the ejector assembly (ejector plate and ejector retainer plate) is milled on each end to the mold base nominal length less 0.06”. The ends of the risers of the ejector housing are drilled and tapped for the 5/16-18 button-head cap screws that fasten the covers to both ends of the ejector housing. |   |
|||||||||||||||||||||
|
