DESIGN GUIDELINES & CONSIDERATIONS FOR THE #ER-101 EARLY EJECTOR RETURN
  1. FOUR UNITS MINIMUM PER MOLD ARE PREFERRED. TWO UNITS PER MOLD MOUNTED ON THE CENTERLINE OF THE MOLD ARE A MUST.
  2. USE GUIDED EJECTION IN THE EJECTOR ASSEMBLY.
  3. USE ONLY IN A HORIZONTAL PRESS.
  4. IF USED IN AN UNBALANCED MOLD, UNEVEN LOADING COULD OCCUR. THIS COULD CAUSE PROBLEMS FOR ER-101 UNITS.
  5. LUBRICATE OCCASIONALLY WITH A LITHIUM TYPE GREASE.
  6. TIMING IS CRITICAL: ALL UNITS TO BE TIMED WITHIN +/-.005 OF ONE ANOTHER.
  7. NO PRELOAD OF UNIT.

 

 

FOR FURTHER INFORMATION ON THE D-M-E ER-101 EARLY EJECTOR RETURN REFER TO THE INSTALLATION INSTRUCTIONS THAT ARE PACKAGED WITH EACH UNIT. IF YOU HAVE FURTHER CONCERNS, PLEASE DO NOT HESITATE TO CONTACT D-M-E APPLICATION ENGINEERING.

 

Er101.doc

OCTOBER, 2004