DESIGN GUIDELINES & CONSIDERATIONS FOR THE "AEP" AND "AEB"

ACCELERATED EJECTORS

 

 

  1. USE THE #AEB-10 FOR UP TO 10-7/8 WIDE X 23-1/2 LONG MOLD BASES.
  2. USE THE #AEB-20 FOR UP TO AND INCLUDING 23-3/4 WIDE X 35-1/2 LONG MOLD BASES.
  3. USE GUIDED EJECTION IN EJECTOR ASSEMBLY.
  4. MAXIMUM STROKE FOR ANY UNIT IS 5/8. THIS PROVIDES A 2:1 RATIO.
  5. USE EARLY EJECTOR RETURN TO RETURN EJECTOR ASSEMBLY.
  6. THE ACCELERATED EJECTORS SHOULD NOT BE USED TO OVERCOME SPRINGS. SPRINGS CAN CAUSE THE PLATE TO DEFLECT AND BIND.
  7. WHEN USING THE AEB DEVICE, A MINIMUM OF FOUR UNITS ARE REQUIRED.
  8. LUBRICATE PINION OCCASIONALLY WITH A LITHIUM TYPE GREASE OR OIL CONTAINING P.T.F.E.
  9. AEB AND AEP UNITS: BODY AND RACKS ARE CARBURIZED TO R/C 45-50.

 

FOR FURTHER INFORMATION ON THE D-M-E ACCELERATED EJECTORS REFER TO THE INSTALLATION INSTRUCTIONS THAT ARE PACKAGED WITH EACH UNIT. IF YOU HAVE FURTHER CONCERNS, PLEASE DO NOT HESITATE TO CONTACT D-M-E APPLICATION ENGINEERING.

 

Accejector.doc

OCTOBER, 2004