FAQs - Angle-Pin-Inserts
Does DME offer front-load inserts?
A: Not at this time.
Where do I find information this product and recommended installations?
A: The product is shown on page 14.1 of the DME Mold Components Catalog. Angle Pin inserts are “rear-load” meaning that the inserts are installed from the stationary-side of the A-plate (as shown on the afore-mentioned catalog page). Angle pins and angle pin inserts are used to actuate sliding core blocks and are often used in conjunction with a form of core slide retainer (DME offers several forms of slide retainers).
Product dimensions are given on page 14.1 of the DME Mold Components Catalog. Recommended installation specifications are also given in the form of printed instructions that are packaged with the product. If you would like an electronic copy of these instructions, please contact us. Please note that mold makers are expected to fit the inserts to the mold, and are responsible for adding an anti-rotation key to prevent rotation of the angle pin insert.
For additional information regarding DME Angle Pin Inserts, please refer to the DME Mold Components Catalog. For other concerns regarding DME Angle Pin Inserts, please contact us by visiting our website at http://www.dme.net, or contact your regional DME sales representative. In the USA or Canada only, please contact DME Customer Service by visiting our website at http://www.dme.net, or call 800-626-6653 (U.S.) or 800-387-6000 (Canada).
