US Section E - page 73

419
U.S. 800-626-6653 • Canada 800-387-6600 • Worldwide +1-248-398-6000
DME price list:
E
High Flow Cascade
To Increase
Production up to 65%
Just Add Water.
*The performance of the High-Flow Cascade series
was recently tested and compared to existing
nipple-type cascades through experimentation
conducted at the University of Wisconsin-
Milwaukee. A computerized heat transfer analysis
was conducted and an overall energy balance was
per­formed. It was found that the heat transfer
rate was dependent largely on the mass flow
rate of the coolant. The greater the mass flow
rate of the coolant, the greater the overall heat
transfer rate of the cascade. The test results are
summarized in graphical form and shown above.
This data shows the new design creates a
35%–65% increase in overall cooling rates.
The High-Flow Cascade series has been engineered to
provide the mold user with a leak-free cooling system
capable of main­tain­ing faster cycle time settings.
Tests have proven that the all High-Flow Cascade
Water Junction cools be­tween 35%–65% faster, and
elim­i­nates leaks caused by pipe nipple interference.*
The High-Flow Cascades increase flow rates by using
a thin-walled stainless steel tube and a new off-set
design. By elim­i­nat­ing the pipe plug and off-setting
the mold nipple in the brass head, all con­nect­ing pipes
can be completely tightened without in­ter­fer­ence or
choking off flow. The High-Flow stainless tubes can be
adjusted to any length and are threaded into the solid
brass head for firm support.
Basic sizes and center distances are in­ter­change­
able with existing units. Brass heads can be ordered
separately along with tubes in any length.
If water junction cooling rates are limiting your cycle
times, or connection leakage is a problem, the High-Flow
Cas­cade Water Junction is your answer.
HIGH- FLOW CASCADE
Pressure (P.S.I)
Flow (Gal.Min.)
STANDARD CASCADE
2
10
20
30
40
50
3
4
5
6
If cooling rates are limiting cycle
times, or connection leakage is a
problem, the High Flow Cascade
is your answer.
Increased inlet areas
produce higher flow rates.
Offset
Hex
Size
PipeTap Size (2)
E
C
L
Mold Nipple Size
High Flow
Tube O.D.
1...,63,64,65,66,67,68,69,70,71,72 74,75,76,77,78,79,80,81,82,83,...126
Powered by FlippingBook